Yanmar — 4.3.2 Reassembly

4. Disassembly and reassembly (19) Mounting the marine gearbox 1) Mount the damper disk to the flywheel. Align the damper disk with the input shaft spline and insert. 2) Mount the marine gearbox to the flywheel housing. Damper disk Flywheel (20) Mounting the cylinder head 1) Put the cylinder head gasket on the cylinder block, aligning it with the cylinder block positioning pins. 2) Lift the cylinder head horizontally and mount it aligning with the cylinder head gasket. 3) Coat the flange part and thread of the cylinder head bolt with engine oil, and lightly tighten the bolts in the specified order first. Then tighten completely, in the same order.

Assembly Camshaft side Flywheel side 10 13 7 12 3 1 6 Gear case side 8 11 9 5 4 14 2 Head bolt tightening order 3 cylinder head ( ) Fuel pump side Tightening torque N•m (kgf•m) 006757-00E Assembly Camshaft side Flywheel side 6 7 3 10 Gear case side 1 2 4 9 5 8 Fuel pump side Head bolt tightening order 2 cylinder head ( ) 006758-00E (21) Mounting the rocker arm shaft assembly and pushrods Rocker arm Adjusting screw 1) Fit the pushrod to the tappet. 2) Coat the top of the pushrod and the adjusting screw of the rocker arm with engine oil. (Apply lube oil to the screw and lock nut.) Mount the rocker arm shaft assembly to the cylinder head and tighten the bolts.

Valve clearance Lock nut Engine oil 3) Adjust valve clearance mm 4) Coat the rocker arm and valve spring with engine oil and mount the rocker arm cover. 96R1 1st step Final Cylinder head bolt 24-32 (2.5-3.3) 53.9-57.9 (5.5-5.9) Intake/exhaust valve clearance 0.15-0.25