Yanmar — 4.3.2 Reassembly

4. Disassembly and reassembly (22) Mounting the fuel injection pump 1) Lightly fit the fuel injection pump on the gear case. (After adjusting injection timing, tighten the fuel injection pump. Before mounting the heat exchanger to the cylinder head, adjust the injection timing.). Fuel injection pump drive gear Camshaft gear NOTE: Be careful not to scratch the O-ring between the fuel injection pump and gear case. C C B B Idle gear A 2) Fit the fuel injection pump drive gear to the fuel pump camshaft. 3) Align the "C" match marks on the fuel injection pump drive gear and idle gear. 4) Tighten the pump drive gear nut to the specified torque.

(Do not apply lube oil to the nut.) A Crankshaft gear Direction of rotation (Gear train) Tightening torque N•m (kgf•m ) 5) Measure the backlash of the fuel injection pump drive gear. Backlash mm (23) Mounting the fuel injection nozzle 1) Replace the used fuel nozzle protector and fuel nozzle seat with new ones. Put the seat in the cylinder head and the protector to the nozzle tip. Mount the fuel injection nozzle to the cylinder head. 2) Tighten the fuel nozzle retainer bolt to the specified torque.

(Do not apply lube oil to the bolt.) Fuel injection nozzle Nozzle protector Nozzle seat Nozzle seat Cylinder head Tightening torque N•m (kgf•m) 97 Pump drive gear nut 58.9-68.7 (6.0-7.0) Fuel injection pump drive gear 0.06-0.12 Fuel nozzle retainer bolt 49.0-53.0 (5.0-5.4)