Yanmar — 5.2.1 Inspecting the cylinder head

5. Inspection and servicing of basic engine parts 5.2.1 Inspecting the cylinder head The cylinder head is subjected to very severe operating conditions with repeated high pressure, high temperature and cooling. Thoroughly remove all the carbon and dirt after disassembly and carefully inspect all parts. (1) Distortion of the combustion surface Carefully check for cylinder head distortion as this leads to gasket damage and compression leaks. 1) Clean the cylinder head surface. 2) Place a straight-edge along each of the four sides and each diagonal. Measure the clearance between the straight-edge and combustion surface with a feeler gauge.

Straight-edge mm Thickness gage (Distortion at combustion surface) (2) Checking for cracks in the combustion surface Remove the fuel injection nozzle, intake and exhaust valve and clean the combustion surface. Check for discoloration or distortion and conduct a color check test to check for any cracks. (3) Checking the intake and exhaust valve seats Check the surface and width of the valve seats. If they are too wide, or if the surfaces are rough, correct to the following standards: 108 Standard Wear limit Cylinder head distortion 0.05 or less 0.15 Seat angle Intake 120° Exhaust 90° Seat width Standard Limit Intake 1.07-1.24 1.74 Exhaust 1.24-1.45 1.94