Yanmar — 5.2.2 Valve seat correction procedure

5. Inspection and servicing of basic engine parts 5.2.2 Valve seat correction procedure The most common method for correcting unevenness of the seat surface with a seat grinder is as follows: (1) Use a seat grinder to make the surface even. As the valve seat width will be enlarged, first use a 70 ° grinder, then grind the seat to the standard dimension with a 15 ° grinder. Seat grinder NOTE: When seat adjustment is necessary, be sure to check the valve and valve guide. If the clearance exceeds the tolerance, replace the valve or the valve guide, and then grind the seat. Seat width Seat (2) Knead valve compound with oil and finish the valve seat with a lapping tool.

(3) Final finishing should be done with oil only. Lapping tool Use a rubber cap type lapping tool for cylinders without a lapping tool groove with oil only. NOTE: Clean the valve and cylinder head with light oil or the equivalent after valve seat finishing is completed and make sure that there are no grindings remaining. (Valve lapping tool) NOTE: 1) Insert adjusting shims between the valve spring and cylinder head when seats have been refinishing with a seat grinder. 2) Measure valve distortion after valve seat refinishing has been completed, and replace the valve and valve seat if it exceeds the tolerance. 109