5. Inspection and servicing of basic engine parts 4) Measure spring tension. Spring tension tester 5) Assembling valve springs. 007535-00E NOTE: The pitch of the valve spring is not even. The side with the smaller pitch (yellow) should face down (cylinder head) when assembled. 6) Spring retainer and spring cotter Inspect the inside face of the spring retainer, the outside surface of the spring cotter, the contact area of the spring cotter inside surface and the notch in the head of the valve stem. Replace the spring retainer and spring cotter when the contact area is less than 70%, or when the spring cotter has been recessed because of wear.
5.2.5 Assembling the cylinder head Camshaft side Disassembly Partially tighten the bolts in the specified order and then tighten to the specified torque, being careful that the head does not get distorted. 2 3 5 12 8 14 Gear case side 9 (1) Clean out the cylinder head bolt holes. 2 6 10 13 11 7 1 (2) Check for foreign matter on the cylinder head surface where it comes in contact with the block. Head bolt disassembly order (3 cylinder head) Assembly Camshaft side Gear case side 13 7 3 1 6 10 12 (3) Coat the head bolt threads and nut seats with lube oil. 14 11 9 5 4 2 (3 cylinder head) Head bolt tightening order 8 (4) Use the positioning pins to line up the head gasket with the cylinder block.
Camshaft side Disassembly 4 1 5 10 8 Gear case side (5) Match up the cylinder head with the head gasket and mount. 2 6 9 3 Assembly (2 cylinder head) Head bolt disassembly order 7 N•m (kgf•m) Camshaft side Gear case side 7 3 1 6 10 8 9 5 2 4 (2 cylinder head) Head bolt tightening order 006759-00E 113R1 Valve spring Unit Standard Limit Free length A mm 37.8 36.3 Inclination B mm - 1.3 Tension (1 mm pressure) (Smaller pitch/ Larger pitch) N/mm (kgf/mm) 26.6/35.4 (2.71/3.61) - Up side Down side Smaller pitch side (yellow) First Second Cylinder head bolt tightening torque 27.0-33.0 (2.8-3.4) 53.9-57.9 (5.5-5.9)