5. Inspection and servicing of basic engine parts 5.2.6 Measuring top clearance (1) Place a high quality fuse ( Ш 1.5 mm, 10 mm long) in three positions on the flat part of the piston head. (2) Assemble the cylinder head gasket and the cylinder head and tighten the bolts in the specified order to the specified torque. (3) Turn the crank, (in the direction of engine revolution), and press the fuse against the piston until it breaks. (4) Remove the head and take out the broke fuse. (5) Measure the three positions where each fuse is broken and calculate the average.
001515-00E Fuse wire 5.2.7 Intake and exhaust rocker arms The wear of rocker arm and rocker arm bushing may change opening/closing timing of the valve, and may in turn affect the engine performance according to the extent of the change. (1) Rocker arm shaft and rocker arm bushing Measure the outer diameter of the shaft and the inner- diameter of the bushing, and replace if wear exceeds the limit. mm (Rocker arm hole diameter) 001516-00E Replace the rocker arm bushing if it moves and replace the entire rocker arm if there is no tightening clearance. (2) Rocker arm spring Check the rocker arm spring and replace it if it is corroded or worn.
(3) Rocker arm and valve top retainer wear (4) Inspect the contact surface of the rocker arm and replace it if there is abnormal wear or flaking. 114R1 Model Top clearance (mm) 3YM30 0.747-0.891 3YM20/2YM15 0.697-0.841 Standard Limit Outside dia of intake and exhaust rocker arm shaft. 11.966-11.984 11.94 Intake and exhaust rocker arm bushing inside dia. 12.000-12.020 12.07 Rocker arm shaft and bushing clearance at assembly 0.016-0.054 0.13