5. Inspection and servicing of basic engine parts 5.3 Piston and piston pins Pistons are made of a special light alloy with superior thermal expansion characteristics, and the top of the piston forms a combustion chamber. 1st compression ring ID marks for piston size 2st compression ring ML Oil ring MS IMPORTANT : Piston shape differs among engine models. If any incorrect piston is installed, combustion performance will drop. Be sure to check the applicable engine model identification mark on the piston to insure use of the correct part. Piston Piston pin I.D.
mark Circlip 5.3.1 Piston (1) Piston head and combustion surface Remove the carbon that has accumulated on the piston head and combustion surface, taking care not to scratch the piston. Check the combustion surface for any damage. (2) Measurement of piston outside diameter/ inspection 1) Replace the piston if the outsides of the piston or ring grooves are worn. 2) Measure the outside diameter in the position of 22mm from the piston bottom in the right angle direction of the piston pin. Piston outside diameter Measurement position 22 mm (Piston outside diameter) If the piston outside diameter exceed the limit, replace the piston with new one.
Selective pairing of cylinder and piston Piston must be paired with cylinder according to the below table. The size mark of a piston is shown on the top surface of the piston and the size mark of a cylinder block is shown on the non-operating side of the cylinder block. The service parts of pistons are provided. 116R1 Model ID marks for engine model 3YM30 76K 3YM20/2YM15 70 Model Standard Limit Clearance between piston and cylinder 3YM30 75.965- 75.975 75.920 0.035-0.055 3YM20 2YM15 69.970- 69.980 69.925 0.030-0.050