Yanmar — 5.4.2 Crank pin metal

5. Inspection and servicing of basic engine parts (2) Checking the side clearance of a connecting rod Fit the respective crank pins to the connecting rod and check to make sure that the side clearance in the crankshaft direction is correct. Crankshaft Thickness gage (Connecting rod side gap) 5.4.2 Crank pin metal (1) Checking crank pin metal Check for flaking, melting or seizure on the contact surface of the crank pin metal. (2) Measuring crank pin oil clearance Measure the crankpin outside diameter and the crank pin metal inside diameter. Calculate the oil clearance from the measured values.

(Refer to 5.5.1(3) for measuring the crank pin outside diameter.) Replace the crank pin metal if the oil clearance becomes about the limit dimension of the below table. Correct by grinding if unevenly wear, roundness exceeding the limit or insufficient outside diameter is found. Also use an undersized metal if necessary. [NOTICE] When measuring the inside diameter of the rod big end, install the crank pin metal in the rod big end not to mistake the top and bottom of the metals and tighten the rod bolts by the standard torque. Cylinder gage N•m (kgf•m) (Rod bushing I.D.

measurement) 3YM30 mm 3YM20/2YM15 mm 122R1 Standard Limit Connecting rod side clearance 0.20-0.40 0.55 Rod bolt tightening torque 22.6-27.5 (2.3-2.8) Item Standard Limit Crankpin O.D. 41.952-41.962 41.902 Metal I.D. 41.982-42.010 - Metal thickness 1.503-1.509 - Clearance 0.020-0.058 0.120 Item Standard Limit Crankpin O.D. 37.952-37.962 37.902 Metal I.D. 37.982-38.010 - Metal thickness 1.503-1.509 - Clearance 0.020-0.058 0.120