Yanmar — 5.7.2 Gear timing marks

5. Inspection and servicing of basic engine parts 5.7 Timing gear The timing gear is helical type for minimum noise and specially treated for high durability. 5.7.1 Inspecting the gears (1) Inspect the gears and replace if the teeth are damaged or worn. (2) Measure the backlash of all gears that mesh, and replace the meshing gears as a set if wear exceeds the limit. NOTE: If backlash is excessive, it will not only result in excessive noise and gear damage, but also lead to bad valve and fuel injection timing and a decrease in engine performance. mm (3) Idling gear The bushing is pressure fitted into the idling gear.

Measure the bushing inner diameter and the outer diameter of the shaft, and replace the bushing or idling gear shaft if the oil clearance exceeds the wear limit. A, B and C are inscribed on the end of the idling gear. When assembling, these marks should align with those on the cylinder block. mm Idle gear Idle gear bushing Idle gear shaft 5.7.2 Gear timing marks Match up the timing marks on each gear when assembling (A, B and C). Fuel injection pump drive gear Camshaft gear C C B B A Idle gear A Crankshaft gear Direction of rotation (Gear train) 131R1 Standard Limit Backlash 0.06-0.12 0.14 Standard Limit Idle gear shaft diameter 36.950-36.975 36.900 Idle gear bushing inside dia.

37.000-37.025 37.075 Oil clearance 0.025-0.075 0.175