Yanmar — 5.6.2 Tappets

5. Inspection and servicing of basic engine parts 5.6.2 Tappets (1) The tappets are offset to rotate during operation and thereby prevent uneven wearing. Check the contact of each tappet and replace if excessively or unevenly worn. NOTE: When removing tappets, be sure to keep them separate for each cylinder and intake/exhaust valve. Abnormal contact surface Normal contact surface (Tappet) 001552-00E (2) Measure the outer diameter of the tappet, and replace if worn beyond the limit. mm (Tappet stem outside diameter measurement) 001553-00E (3) Measuring push rods. Measure the bend of the push rods.

mm Thickness gage (Push rod bend) 001554-00E 130R1 Standard Limit Tappet outside diameter 20.927-20.960 20.907 Tappet guide hole inside dia. (cylinder block) 21.000-21.021 21.041 Oil clearance 0.040-0.094 0.134 Standard Limit Push rod bend Less than 0.03 0.03