5. Inspection and servicing of basic engine parts (3) Camshaft and bearing hole measurement mm Flywheel side Micrometer Measure the camshaft outside diameter with a micrometer. The oil clearance shall be calculated by subtracting the measured camshaft outside diameter from the inside diameter of the camshaft bearing or bushing. The camshaft bushing at gear case side is measured with a cylinder gage after insertion to the cylinder. Replace if they exceed the limit or are damaged. (Camshaft outside diameter) mm (4) Bending of the camshaft Support both ends of the camshaft with V-blocks, place a dial gauge at the central bearing areas and measure bending. Replace if excessive. Dial gage NOTE:
The reading on the dial gauge is divided by two to obtain the camshaft bend. mm V-block (Camshaft bend) 129 Standard Limit Cam height Intake 34.135-34.265 33.89 Exhaust Item Standard Limit Gear side Bushing I.D. 40.000-40.075 40.150 Camshaft O.D. 39.940-39.960 39.905 Oil clearance 0.040-0.135 0.245 Intermediate position Bushing I.D. 40.000-40.025 40.100 Camshaft O.D. 39.910-39.935 39.875 Oil clearance 0.065-0.115 0.225 Flywheel side Bushing I.D. 40.000-40.025 40.100 Camshaft O.D. 39.940-39.960 39.905 Oil clearance 0.040-0.085 0.195 Standard Limit Camshaft bend 0.02 or less 0.05