8. Lubrication system 8.2 Lube oil pump 8.2.1 Lube oil pump construction The trochoid type lube oil pump is mounted in the gear case cover, and the inner rotor is driven by the crankshaft pulley. The lube oil flows from the intake filter mounted on the bottom of the cylinder body through the holes in the cylinder body and engine plate, and out from the holes in the engine plate and cylinder body to the discharge filter. The lube oil pump is fitted with a control valve, which controls the discharge oil pressure at the specified pressure.
Cover Outer rotor Inner rotor Control valve Gear case cover Crankshaft pulley 8.2.2 Specifications of lube oil pump Lube oil pump specifications 8.2.3 Lube oil pump disassembly and reassembly Disassembly (1) Remove the crankshaft pulley. (2) Remove the gear case cover. (3) Remove the lube oil pump cover from the gear case cover. Do not disassemble the inner /outer rotors, and check that the pump rotates smoothly. (4) Remove the pressure control valve from the lube oil pump cover. Note : Only wash the control valve. Disassembly is unnecessary unless any abnormality in operation is detected. Reassembly [NOTICE] Always check if the pump rotates smoothly after installation on the gear case.
Running the engine when the pump rotation is heavy may cause the pump to be burnt. (1) Apply lube oil to rotor (outer/inner) insertion part. (2) Fasten the pump cover by the standard torque. (3) When replacing the lube oil pump, replace the whole assy. 153R1 Engine speed 3600 (min-1) 800 (min-1) Pump speed 3477 (min-1) 772 (min-1) Delivery quantity º19.0 (l/ min-1) º8.0 (l/ min-1) Delivery pressure 0.43 MPa (4.4 kgf/cm2) º0.049 MPa (0.5 kgf/cm2) Oil temp. 60±5 (°C) I Tightening torque 5.9-7.9 N•m (0.6-0.8 kgf•m)