Yanmar — 8.2.5 Pressure control valve construction

8. Lubrication system 8.2.4 Lube oil pump inspection (1) Outside diameter clearance and side clearance of outer rotor Insert a gap gauge between the outer rotor and the gear case cover, and measure outside diameter gap. Put a ruler on the end face of the gear case cover, and insert a gap gauge between rotor, and measure a side gap. Gear case Outer rotor Outside clearance mm Inner rotor (Outer diameter clearance) (2) Tip clearance between outer rotor and inner rotor Insert a gap gage between an outer rotor and an inner rotor, and measure the tip clearance.

Tip clearance mm (3) Side clearance When measuring a side clearance, put a right-angle gage to the pump body, insert a gap gage and measure the clearance. Side clearance mm (Side clearance) Outer rotor (4) Outside diameter clearance of inner rotor centering location part Measure the outside diameter of inner rotor centering location part and the hole diameter of gear case cover. Calculate the clearance from that difference. 8.2.5 Pressure control valve construction The pressure control valve controls the oil pressure from the time the lube oil leaves the filter.

When the pressure of lube oil entering the cylinder body main gallery exceeds the standard, the control valve piston opens the bypass hole and lube oil flows back into the oil pan. 154 Standard Limit 0.12-0.21 0.30 Standard Limit - 0.16 Standard Limit 0.02-0.07 0.12 Inspection item Standard Limit Gear case cover I.D. 46.13-46.18 - Inner rotor O.D. 45.98-46.00 - Rotor clearance 0.13-0.20 0.25 Standard oil pressure 0.29-0.44 MPa (3.0-4.5 kgf/cm2)