9. Cooling water system 9.4 Heat exchanger 9.4.1 Heat exchanger construction The heat exchanger cools the hot fresh water, that has cooled the inside of the engine, with seawater. The cooler core consists of many small diameter tubes, baffle plates and tube cover. The seawater flows through the maze formed by the baffle plates. There is a reservoir above the cooler core, which serves as the fresh water tank. There is an exhaust gas passageway in the reservoir, which forms a water cooled exhaust manifold.
The pressure cap (filler cap) on top of the heat exchanger has a pressure valve, which lets off steam through the overflow pipe when pressure in the fresh water system exceeds the specified value. It also takes in air from the overflow pipe when pressure in the fresh water system drops below the normal value. Gasket Side cover O-ring Cooler core Filler neck Pressure cap Overflow pipe Side cover O-ring 9.4.2 Disassembly and reassembly of the heat exchanger (1) Remove the side covers on both sides of the cooler core and take out the cooler core and O-ring(s). NOTE: Replace the O-ring(s) when you have removed the cooler core. (2) Remove the pressure cap.
9.4.3 Heat exchanger inspection Refer to 2.2.6(4). 165