Yanmar — 12.7.2 Cooling water temperature alarm

12. Electrical System Inspection 12.7.2 Cooling water temperature alarm A water temperature lamp and a water temperature switch (thermo switch), backed up by an alarm in the instrument panel, are used to monitor the temperature of the engine cooling water. A high thermal expansion material is set on the end of the water temperature unit. When the cooling water temperature reaches a specified high temperature, the contacts are closed, and an alarm lamp and buzzer are activated at the instrument panel.

Pilot lamp Fuse Main switch Water temperature switch Alarm buzzer Water temperature unit Battery (Water temperature alarm circuit) 54.3 mm M16 x 1.5 Fresh water pump Black 198 Problem Inspection Item Inspection method Corrective action Lamp not illuminated when main switch set to ON. 1. Oil pressure lamp blown out. (1) Visual inspection. (2) Lamp not illuminated even when main switch set to ON position and terminals of oil pressure switch grounded. Replace lamp. 2. Operation of oil pressure switch. Lamp illuminated when checked as described in (2) above. Replace oil pressure switch. Lamp not extinguished while engine running. 1. Oil level low. Stop engine and check oil level with dipstick.

Add oil. 2. Oil pressure low. Measure oil pressure. Repair bearing wear and adjust regulator valve. 3. Oil pressure faulty. Switch faulty if abnormal at (1) and (2) above. Replace oil pressure switch. 4. Wiring between lamp and oil pressure switch faulty. Cut the wiring between the lamp and switch and wire with separate wire. Repair wiring harness. Operating temperature ON 93-97 deg. C Electric capacity Response time DC 12V, 1A within 60 sec. I.D. color Black Tightening torque 23.54-31.38 N•m (2.40-3.20 kgf-m)