Yanmar — 2.2.1 Check before starting

2. Inspection and adjustment 2.2 Periodic inspection and maintenance procedure 2.2.1 Check before starting Be sure to check the following points before starting an engine every day. (1) Visual inspection of engine outside If any problem is found, do not use before the engine repairs have been completed. Oil leak from the lubrication system Fuel leak from the fuel system Cooling water leak from the cooling water system Damaged parts Loosened or lost bolts Fuel, coolant tank rubber hoses, V belt cracked, loosened clamp (2) Check the fuel level, and refill Check the remaining fuel oil level in the fuel tank and refill the recommended fuel if necessary.

(3) Check the lube oil level (Crankcase/Marine gear) 1) Checking engine lube oil level a) Check the lube oil level of a engine with a dipstick. Insert the dipstick fully and check the oil level. The oil shall not be contaminated heavily and have appropriate viscosity. No cooling water or diesel fuel shall be mixed Standard The level shall be between the upper and lower limit lines on the dipstick. Unit : liter (quart) b) If the remaining engine oil level is low, fill the oil pan with the specified engine oil to the specified level through the filler port. [NOTICE] The engine oil should not be overfilled to exceed the upper limit line.

If engine oil is overfilled, the engine may intake the engine oil in the combustion chamber during the operation, and white smoke, oil hummer or urgent rotation may occur, because the blowby gas is reduced in the suction air flow. 17R1 No.

Inspection Item (1) Visual inspection of engine outside (2) Check the fuel level, and refill (3) Check the lube oil level (Crankcase/Marine gear) (4) Seawater outlet (5) Check cooling water level (6) Check the alarm lamps & devices (7) Check the leakage of water, lube oil and fuel (8) Check/adjust the remote control operation Filler port Dipstick Upper limit Lower limit Model Rake angle Engine oil capacity (Full) 3YM30 with KM2P-1 8 degree 2.8 0/ (3.0) -0.2 3YM20 with KM2P-1 2.7 0/ (2.9) -0.2 2YM15 with KM2P-1 2.0 0/ (2.1) -0.2 3YM30C with SD20 0 degree 2.5 0/ (2.6) -0.2 3YM20C with SD20 2.4 0/ (2.5) -0.2 2YM15C with SD20 1.8 0/ (1.9) -0.2