Yanmar — 2.2.1 Check before starting

2. Inspection and adjustment 2) Checking marine gear lube oil level a) Check the lube oil level of the marine gear with a dipstick. Dipstick Upper limit Unit: liter (pint) Lower limit b) When the level is low, remove a oil filler cap at the top of the housing, and fill it with marine gear- clutch- lube oil to the upper limit on the dipstick. c) Tighten the oil filler cap securely by hand. Lube oil supply port 007531-00E (4) Seawater outlet Check whether seawater comes out just after the engine has started. If seawater doesn't come out, shut down the engine immediately. Check the leakage of seawater in the seawater pass and the damage of the seawater pump impeller.

(5) Check cooling water level Daily inspection of cooling water should be done only by coolant recovery tank. Never open the filler cap while the engine is still hot. Steam and hot water will spurt out and seriously burn you. Wait until the engine is cooled down after the engine stopped, wrap the filler cap with a rag piece and turn the cap slowly to gently release the pressure inside the flesh water tank. Securely tighten the filler cap after checking the flesh water tank. If the cap is tightened loosely, steam can spurt out during operation. 1) Checking cooling water volume Check the cooling water level in the coolant recovery tank.

If the water level is close to the LOW mark, open the coolant recovery tank cap and replenish the coolant recovery tank with clean soft water to the FULL mark. To fresh water cooler Cap Upper limit FULL Standard The water level of the coolant recovery tank shall be between the upper and lower limit lines. Lower limit Coolant recovery tank LOW 2) Replenishing engine with water If the cooling water leveling the coolant recovery tank is lower than the LOW mark, open the filler cap and check the cooling water level in the coolant tank. Replenish the engine with the cooling water, if the level is low. Check the cooling water level when the engine is cool.

Checking when the engine is hot is dangerous. And the water volume is expanded due to the temperature. Daily cooling water level check and replenishing shall be done only at the coolant recovery tank. Usually do not open the filler cap to check or replenish. Standard Cooling water volume Unit : liter (quart) 18R1 Marine gear oil capacity KM2P-1 Full : 0.30 (0.64) Model Engine Coolant recovery tank 3YM30 4.9 (5.2) 0.8 (0.8) 3YM20 4.1 (4.3) 0.8 (0.8) 2YM15 3.0 (3.2) 0.8 (0.8)