Yanmar — 2.2.2 inspection after initial 50 hours or one month operation

2. Inspection and adjustment (4) Adjust the tension of the alternator drive belt When there is not enough tension in the V-belt, it will slip and the cooling water pump will fail to supply cooling water. Engine over-heating and the seizure will occur. When there is too much tension in the V-belt, the belt will become damaged more quickly and the bearing of the cooling water pump may be damaged. Check and adjust the V-belt tension (deflection) in the following manner. [Notice] Be especially careful not to splash engine oil on the V-belt, because it will cause slipping, stretching and aging of the belt. 1) Remove the belt cover.

Check the tension of the V- belt by pressing down on the middle of the belt with your finger [approx. 98N(10kgf)]. The specified deflection should be as follows. "New V-belt" refers to a V-belt which has been used less than 5 minutes on a running engine. "Used V-belt" refers to a V-belt which has been used on a running engine for 5 minutes or more. 2) If necessary, adjust the V-belt tension (deflection). To adjust the V-belt tension, loosen the set bolt for the belt adjuster and move the alternator to tighten the V-belt. 3) Visually check the V-belt for cracks, oiliness or wear. If any, replace the V-belt with new one.

[Notice] When the V-belt will be replaced with new one, loosen the set bolt, move the alternator and also loosen the V-pulley set bolts for the cooling water pump. Remove the V-belt. After replacing with a new V-belt and adjusting the tension, run the engine for 5 minutes and readjust the deflection to the value in the table above. 22R1 Push For used V-belt 8-10 mm (0.315-0.393 inches) For new V-belt 6-8 mm (0.236-0.315 inches) . r r , r Alternator Bracket Set bolt V-belt Belt adjuster (3YM30)