Yanmar — 2.2.2 inspection after initial 50 hours or one month operation

2. Inspection and adjustment (5) Adjusting the intake/exhaust valve clearance Make measurement and adjustment while the engine is cold. 1) Valve clearance measurement a) Remove the rocker arm cover above cylinder head. b) Set the No.1 cylinder in the compression TDC Turn the crankshaft to bring the piston of the No.1 cylinder to its compression top dead center while watching the rocker arm motion, the timing mark of the flywheel housing and the top mark of the flywheel. (Position where both the intake and exhaust valves are closed.) Flywheel housing Injection timing marks No.1 cylinder 1 T.D.C. Flywheel Hole (Notes) The crankshaft shall be turned clockwise as seen from the gear case side.

The No.1 cylinder position is on the opposite side of the gear case. Since there is a clearance between the rocker arm and valve at the compression top dead center, the position of TDC can be checked by hand. Also see that the top mark on the flywheel aligns with the mark on the flywheel housing. If there is no valve clearance, disassemble and inspect around the valve seat, since the valve seat may be worn abnormally. c) Valve clearance measurement Insert a thickness gage between the rocker arm and valve cap, and record the measured valve clearance.

(Use it as the data for estimating the wear state.) d) Adjusting other cylinders Turn the crankshaft 240 ° and make adjustment for the No.3 cylinder. Then adjust the No.2 cylinder in this order. The cylinder to be adjusted first does not have to be the No.1 cylinder. Select and adjust the cylinder where the piston is the nearest to the top dead center after turning, and make adjustment for other cylinders in the order of ignition by turning the crankshaft 240 ° e ach time. Rocker arm Adjusting screw Valve clearance Lock nut (Valve clearance) The adjustment method of reducing the flywheel turning numbers (for reference): Set No.1 cylinder to the compression T.D.C.

and adjust the clearance of the z mark of the below table. Next, turn the flywheel once (the suction/ exhaust valve of No.1 cylinder is in the position of the overlap T.D.C. at this time), and adjust the clearance of the { mark. Ignition order of 3 cylinder engines: 1 3 2 2) Valve clearance inspection and adjustment a) Loosen adjusting bolts Loosen the lock nut and adjust the screw. And check the valve for any inclination of valve cap, entrance of dirt or wear. Valve cap (Normal) (Abnormal) 23 Cylinder No. 1 2 3 Valve Suction Exhaust Suction Exhaust Suction Exhaust No.1 compression T.D.C z z z z The first time No.1 overlap T.D.C { { The second time