2. Inspection and adjustment b) Measure valve clearance Insert a 0.2 mm thickness gage between the rocker arm and valve cap, and adjust the valve clearance. Tighten the adjusting bolt. Standard valve clearance (mm) 0.15-0.25 c) Apply oil to the contact surface between adjusting screw and push rod. d) Adjusting other cylinders Turn the crankshaft 240 ° then and make adjustment for the No.3 cylinder. Then adjust the No.2 cylinder in this order. The cylinder to be adjusted first does not have to be the No.1 cylinder.
Select and adjust the cylinder where the piston is the nearest to the top dead center after turning, and make adjustment for other cylinders in the order of ignition by turning the crankshaft 240 ° each time. (Valve clearance adjustment) (6) Check and adjust the remote control operation The various control levers on the engine side are connected to the remote control lever by the remote control cable. The cable will become stretched and the attachments loose after long hours of use causing deviation. It is dangerous to control operation under these conditions, and the remote control cable must be checked and adjusted periodically.
1) Adjusting the throttle remote control cable Check to see that the control lever on the engine side moves to the high speed stop position and low speed stop position when the remote control lever is moved to H (high speed) and L (low speed) respectively. When there is deviation, loosen the clamp for the remote control cable on the engine side and adjust. Adjust the high speed stop position first and then adjust the low speed idling by the adjustment bolt on the remote control lever. Never adjust the high speed limiting bolt. This will void warranty.
2) Adjusting the clutch remote control cable Check that the shift lever moves to the correct position, when the remote control handle is put in NEUTRAL, FORWARD and REVERSE position. Use the NEUTRAL position as the standard for adjustment. When there is deviation, loosen the clamp for the remote control cable and adjust the shift lever position Clamp Clutch remote control cable REVERSE NEUTRAL FORWARD Shift lever 24 e r ) e d n t Remote High speed control limiting bolt Fuel cable injection pump Low speed Clamp limiting bolt Control lever Cable joint