2. Inspection and adjustment 2.2.6 Inspection every 250 hours or one year Be sure to check the following points every 250 hours or one year operation, whichever comes first. (1) Drain the fuel tank Refer to 2.2.2(1) for the procedure. (2) Replace the fuel filter Replace the fuel filter with new one at the specified interval, before it is clogged with dust to adversely affect the fuel flow. Also, replace the fuel filter after the engine has fully been cooled. 1) Close the fuel cock of the fuel tank. 2) Remove the fuel filter using a filter wrench (customer procured). When removing the fuel filter, hold the bottom of the fuel filter with a piece of rag to prevent the fuel oil from dropping.
3) Clean the filter mounting surface and slightly apply fuel oil to the gasket of the new fuel filter. 4) Install the new fuel filter manually turning until it comes into contact with the mounting surface, and tighten it further to one turn using a filter wrench. Air bleeding bolt Bracket O-ring Filter element Tightening torque: 20-24N•m Filter cap 5) Bleed the fuel system. Refer to 2.2.3.(1). IMPORTANT: Be sure to use genuine Yanmar part (super fine mesh filter). Otherwise, it results in engine damage, uneven engine performance and shorten engine life. Retaining ring (Fuel filter) 31R1 No.
Inspection Item (1) Drain the fuel tank (2) Replace the fuel filter (3) Replace the marine gear lube oil (4) Replace the engine lube oil filter (5) Check the impeller of the cooling water pump (seawater pump) (6) Replace the fresh water coolant (7) Clean the element of the air intake silencer (8) Clean the exhaust/water mixing elbow (9) Adjust the tension of the alternator driving belt (10) Check the wiring connectors Applicable fuel filter element Part No. O-ring Part No. 104500-55710 24341-000440