2. Inspection and adjustment (3) Replace the marine gear lube oil. Refer to 2.2.2(3) for the procedure. (4) Replace the engine lube oil filter. Refer to 2.2.2(2) for the procedure. (5) Check the impeller of the cooling water pump (seawater pump). 1) Remove the seawater pump cover and take out the O-ring, impeller and wear plate. 2) Inspect the rubber impeller, checking for splitting around the outside, damage or cracks, and replace if necessary. Depending on the use, the inside parts of a seawater pump may deteriorate and the discharge performance may drop.
At the specified interval or when the discharge volume of seawater is reduced, inspect the seawater pump in accordance with the following procedures. a) Loosen the seawater pump cover set bolts and remove the cover. b) Illuminate the inside of the seawater pump with a flashlight and inspect. c) If no damage is found, reassemble the cover. d) If any of the following problems are found, take out the O-ring and impeller. If necessary, replace with new one and reassemble the cover. Impeller blades are cracked or nicked. Edges or surfaces of the blades are marred or scratched. O-ring Cover Pump body Impeller (Seawater pump) Note:
The impeller must be replaced periodically (every 1000 hrs or four years whichever comes first). e) If a large amount of water leaks continuously from the water drain pipe beneath the seawater pump during engine operation, check the oil seal inside the seawater pump. [Notice] The seawater pump turns in the counterclockwise direction viewed from driving side. If the impeller has been removed for any reason and must be reassembled, be very careful not to make a mistake in impeller direction and turn it in the wrong direction. Additionally, if the engine is being turned manually, be careful to turn it in the correct direction. Incorrect turning will twist the impeller blades and damage it.
Seawater pump Impeller Impeller rotating direction Direction of impeller 32R1