2. Inspection and adjustment 5) After supplying cooling water, fit the filler cap and tighten it firmly. To reassemble the cap, align the tabs on the bottom of the cap with the notches on the filler port and turn clockwise 1/3 of a turn. 6) Remove the coolant recovery tank cap and fill with coolant mix to the lower limit. Replace the cap to the coolant recovery tank. Coolant recovery tank capacity: 0.8 L (1.7 pints) 7) Check the rubber hose connecting the coolant recovery tank to the fresh water cooler. Be sure the hose is securely connected and there is no looseness or damage. When the hose is not watertight, an excessive amount of cooling water will be used.
To fresh water cooler Cap Rubber hose FULL Coolant recovery tank LOW (7) Clean the element of the air intake silencer 1) Inspection of the intake silencer Occasionally, disassemble the intake silencer, remove the polyurethane element and inspect it. Because the element filters the air, if it is used over a long period of time it will become clogged and this decreases the amount of intake air, and may also be a cause of decreased output. 2) Washing the intake silencer element Wash the air intake silencer element with a neutral detergent. Element 34