2. Inspection and adjustment 2.2.7 Inspection every 1,000 hours or four years Be sure to check the following points every 1,000 hours or four years operation, whichever comes first. (1) Check the injection timing The fuel injection timing is adjusted so that engine performance may become the best condition. As for the inspection and adjustment of the fuel pump, it is based on the service manual of the ML pump. The fuel injection timing is adjusted by the following procedure. 1) Complete air bleeding from the fuel line and set the engine ready for starting. 2) See that the timing marks on fuel pump mounting flange and gear case are aligned.
3) Set the speed control lever at the operating position. 4) Disconnect the injection pipe on the fuel pump side for the No.1 cylinder. (Do not remove the delivery holder.) 5) Check the fuel discharge from the delivery holder while turning the crankshaft clockwise as seen from the radiator, and stop turning it at the same time when the fuel comes out. Wipe out the fuel of the delivery holder exit. Next, turn the crankshaft in the opposite direction (counterclockwise), and return it to about 20 degrees before top dead center. 6) Check again the fuel discharge from the delivery holder while turning the crankshaft clockwise, and stop turning it at the same time when the fuel comes out.
7) Read the timing scale on the flywheel from the hole on the flywheel housing. It is standard fuel injection timing if the timing mark position meets the fuel injection timing of the below table. Flywheel housing Injection timing marks No.1 cylinder T.D.C. Flywheel Hole 8) Repeat the step 5) to 7) a few times. (Note) Injection timing check for one cylinder is generally sufficient. If it is to be checked for all cylinders, check each cylinder in the ignition order of 1-3-2-1 (for 3 cyl. Eng.) or 1-2-1(for 2 cyl. Eng.). The cylinder to be checked is not limited to the No.1 cylinder and any cylinder may be checked.
9) If the injection timing is out of the standard value, loosen the fuel pump mounting nut and incline the fuel injection pump toward or away from the engine for adjustment. Incline toward the engine to delay the timing, and away from the engine to advance it. 37R1 No.
Inspection Item (1) Check the injection timing (2) Check the injection spray condition of a fuel nozzle (3) Check the impeller of the cooling water pump (seawater pump) (4) Clean & check the water passages (5) Diaphragm assembly inspection (6) Adjust the tension of the alternator driving belt (7) Retighten all major nuts and bolts (8) Adjust intake/exhaust valve clearance (9) Check/adjust the remote control operation (10) Adjust the propeller shaft alignment 1 Model Injection timing FID (FIC-Air) degree bTDC 3YM30 16 ± 1 (18 ± 1) 3YM20 22 ± 1 (24 ± 1) 2YM15 21 ± 1 (23 ± 1)