2. Inspection and adjustment (2) Check the injection spray condition of a fuel nozzle Wear protective glasses when testing injection from the fuel injection nozzle. Never approach the injection nozzle portion with a hand. The oil jetting out from the nozzle is at a high pressure to cause loss of sight or injury if coming into careless contact with it. 1) Injection pressure measurement Standard fuel injection pressure MPa (kgf/cm 2 ) 12.3-13.28 (125-135) Nozzle tester [Notice] As for the opening pressure of the brand-new fuel nozzle, about 0.5 MPa (5 kgf/cm) declines by the engine operation for about 5 hours because of the initial wear-out of a spring etc.
Therefore, adjust 0.5 MPa (5 kgf/cm) higher than the standard value of the above table when adjusting a new fuel nozzle of a spare part. Injection nozzle ) ( Injection pressure measurement with nozzle tester Remove carbon deposit at the nozzle hole thoroughly before measurement. a) Connect the fuel injection valve to the high pressure pipe of the nozzle tester. b) Operate the nozzle tester lever slowly and read the pressure at the moment when the fuel injection from the nozzle starts. c) If the measured injection pressure is lower than the standard level, replace the pressure adjusting shim with a thicker one.
38 Thickness of pressure adjusting shims mm Injection pressure adjustment 0.1, 0.2, 0.3, 0.4, 0.5, 0.52, 0.54, 0.56, 0.58, 0.8 The injection pressure is increased by approx. 1.1 MPa (11 kgf / cm2), when the adjusting shim thickness is increased by 0.l mm.