3. Troubleshooting (3) Abnormal vibration (3) Damaged or old lube oil adjustment valve spring Chart 4 TROUBLE WITH MARINE GEAR (1) Excessive backlash of gear TROUBLE WITH MARINE GEAR (4) Sticking of lube oil adjustment valve (III -1) Replace. (III -2) Replace. (III -3) Eliminate dangerous rotation. (VI) Abnormal lube oil pressure (VI-1) Check and repair. (VI-2) Disassemble and clean. (VI-3) Replace. (VI-4) Repair or replace.
(III) Abnormal noise (1) Oil leakage (2) Clogged lube oil filter (2) Damaged bearing (7) Poor operation of low speed valve (4) Too much oil (5) Problem with oil cooler (6) Poor quality or inappropriate oil (3) Lube oil pressure is too high (4) Viscosity of lube oil is too high (2) Damaged holding spring of pipe (II-1) Review (I-1, I-11). (II-2) Reduce load. (II-3) Replace. (II-4) Check oil level and adjust. (II-5) Check water level and adjust. (II-6) Change oil. (II-7) Review manual. (V-1) Replace. (V-2) Replace. (V-3) Adjust lube oil adjustment valve. (V-4) Change oil.
(II) Overheating (1) Clutch slippage due to low oil pressure (2) Clutch slippage due to overloading (1) Not enough warp in steel plate (V) Dragging (3) Damaged bearing (9) Low speed valve handle slips (10) Poor assembly of low speed valve handle (I-7) Replace. (I-8) Replace. (I-9) Adjust to correct position. (I-10) Reassemble. (I-11) Check for oil leakage and replenish. (7) Worn sliding parts of forward/reverse conversion valve (8) Damaged O-ring, V-ring in oil pressure pipe (11) Insufficient oil (IV-1) Replace. (IV-2) Clean.
(I) Low clutch oil pressure (clutch slips) (1) Cogging of filter on suction side (2) Worn oil pump (3) Sticking of oil pressure adjustment valve TROUBLE AND TROUBLESHOOTING (I-1) Disassemble and clean. (I-2) Repair or replace. (I-3) Repair or replace. (I-4) Replace. (I-5) Repair. (I-6) Adjust. Countermeasure Cause and Effect Countermeasure 53 Chart 4 TROUBLE AND TROUBLESHOOTING TROUBLE WITH MARINE GEAR Chart 4 TROUBLE AND TROUBLESHOOTING TROUBLE WITH MARINE GEAR Countermeasure (I-1) Disassemble and clean. (I-7) Replace. (I-2) Repair or replace. (I-8) Replace. (I-3) Repair or replace. (I-9) Adjust to correct position. (I-4) Replace. (I-10) Reassemble. (I-5) Repair.
(I-11) Check for oil leakage (I-6) Adjust. and replenish. (II-1) Review (I-1, I-11). (II-2) Reduce load. (II-3) Replace. (II-4) Check oil level and adjust. (II-5) Check water level and adjust. (II-6) Change oil. (II-7) Review manual. (III -1) Replace. (III -2) Replace. (III -3) Eliminate dangerous rotation.