3. Troubleshooting 61 Malfunctions Causes Remedies 4. The nozzle or the nozzle holder is not functioning properly The engine cannot reach its maximum speed The engine’s maximum speed is too high Idling is unstable 1. The governor spring is too weak or is improperly adjusted 2. The control lever is not reaching the maximum-speed position 3. The nozzle’s injection operation is poor 1. The governor spring is too strong or is improperly adjust 2. The governor flyweights or governor sleeve movement is not smooth 1. The injection quantities are not uniform (the delivery valve is not operating properly) 2. The governor’s idling adjustment is improperly adjusted 3. The plunger is worn 4.
The plunger spring is broken 5. The rubber damper is worn. 6. The governor lever shaft pin is worn excessively 7. The feed pump blades are not operating properly 8. The regulating valve is stuck in the open position 9. The fuel filter element is clogged and therefore fuel oil delivery is poor 10.The nozzle or the nozzle holder is not functioning properly Inspect and then repair or replace Readjust or replace Readjust Repair or replace Readjust or replace Repair or replace Inspect or replace Readjust Replace the distributor assembly Replace Replace Replace Repair or replace Replace Clean or replace Inspect and then repair or replace