3. Troubleshooting 60 Malfunctions Causes Remedies The engine exhaust contains smoke and the engine “knocks” The engine output is unstable Insufficient output 1. The injection quantity is insufficient 2. The injection timing is too advanced and the engine is “knocking” 3. The injection timing is too retarded and the engine is overheating or the exhaust contains smoke 1. The injection timing is incorrect 2. The nozzle or nozzle holder is functioning incorrectly 3. The injection quantity is excessive 1. The fuel filter element is clogged and fuel oil delivery is poor 2. The amount of fuel or pressure delivered by the feed pump is too little 3. The injection pump is sucking air 4.
The regulating valve is stuck in the open position 5. The plunger is sticking and does not travel its full stroke 6. The plunger spring is broken 7. The control sleeve is not sliding smoothly 8. The governor lever is not operating properly or is worn excessively 9. The delivery valve spring is broken 10. The delivery valve is not sliding properly 11.The nozzle or the nozzle holder is not functioning properly 12.The injection timing is incorrect 1. The specified full-load injection quantity is not delivered 2. The control lever is not reaching the maximum speed position 3. The governor spring is weak and therefore the governed speed is too low 4. The plunger is worn 5.
The delivery valve seating portions are damaged Readjust the timing Inspect, then repair or replace Readjust Clean or replace Inspect and repair Inspect and repair Replace Replace the distributor assembly Replace Repair or replace Repair or replace Replace Repair or replace Inspect, and then repair or replace Readjust Readjust Readjust Replace Replace the distributor assembly Replace Readjust Readjust