Yanmar — 3.3 Troubleshooting (Concerning engine and fuel injection equipment)

3. Troubleshooting 3.3 Troubleshooting (Concerning engine and fuel injection equipment) 59 Malfunctions Causes Remedies The engine does not operate 1. Fuel oil is not injected from the injection pump 2. Injection timing is incorrect 3. The nozzle does not operate 4. The engine operates but only for short time 5. The engine “knocks” 1. There is no fuel oil in the fuel tank 2. The fuel line from the fuel tank is blocked 3. The fuel is clogged 4. There is air in the fuel filter or the pump chamber 5. The accelerator linkage is not properly connected 6. The magnet valve wiring is broken or its armature is sticking 7. The feed pump blades are sticking, and therefore not operating 8.

The drive gear or woodruff key is broken 1. The drive gear or belt connections are incorrect 2. The injection pump is incorrectly installed on the engine 3. The roller holder assembly’s roller or pin is worn excessively 4. The plunger is worn excessively 1. The nozzle or nozzle holder is functioning incorrectly 1. The pipe(s) to the injection pump is blocked or the fuel filter is clogged 2. The fuel oil contains air or water 3. The feed pump’s delivery quantity (or pressure) is insufficient 1. The injection timing is too advanced 2.

The nozzle or nozzle holder is functioning incorrectly Supply fuel and bleed the system Clean or replace Clean or replace Bleed the system Repair Repair or replace Repair or replace Replace Repair Repair and adjust injection timing Replace the assembly Replace the distributor assembly Inspect, then repair or replace Clean or replace the pipe(s) or fuel filter Bleed of air or replace the fuel oil Repair or replace Readjust the timing Inspect, then repair or replace