3. Troubleshooting (5) Oil leakage from pump safety valve (6) Inadequate viscosity of lube oil (7) Insufficient amount of lube oil (5) Engine outlet not constricted. (5) Air in cooling water (VI-1) Clean. (VI-2) Check pump and repair. (VI-3) Lessen lift or replace pump. (VI-4) Check suction opening. (VI-5) Eliminate causes for high cooling water temperature and constrict. (VI-6) Check and repair. Chart 9 (III-1) Clean. (III-2) Add cooling water. (III-3) Disassemble and repair or replace. (III-4) Tighten adjustment valve. (III-5) Tighten safety valve. (III-6) Change lube oil. (III-7) Add lube oil. (III-8) Replace.
(8) Faulty pressure gauge MISCELLANEOUS TROUBLE MISCELLANEOUS TROUBLE (6) Water leakage from cooling water joints. (VI) Cooling water pressure is too low (III) Low lube oil pressure (4) Loose pressure adjustment valve (1) Clogging in cooling water system (1) Loose pressure adjustment (1) Clogged lube oil filter (2) Lube oil temperature is too high (3) Trouble with lube oil pump (6) Overloading (2) Trouble with cooling water pump (3) Cooling water lift is too great (4) Air in cooling water (V-1) Open closed parts. (V-2) Check pump and repair. (V-3) Adjust amount of returning water. (V-4) Clean. (V-5) Check suction opening. (V-6) Reduction load. (II-1) Tighten adjustment valve.
(II-2) Check and repair. (II-3) Clean. (II-4) Repair. (V) Cooling water temperature is too high (II) Low fuel oil pressure (3) Clogged filter (4) Leaky pipe (2) Damaged supply pump (1) Insufficient amount of cooling water (2) Trouble with cooling water pump (4) Clogging in cooling (I-1) Tighten nuts. (I-2) Tighten nuts and insert pins. (I-3) Remove adjustment liner and adjust aperture, or replace. (I-4) Check teeth, shaft, and pushrod of gear for wear. Replace where necessary. check (IV-2) Reduce load.
(I) Abnormal noise (1) Loose flywheel installment bolt (2) Loose crank pin bearing bolt TROUBLE AND TROUBLESHOOTING has risen (3) Faulty lube oil temperature Countermeasure Cause and Effect Countermeasure 58 Chart 9 TROUBLE AND TROUBLESHOOTING MISCELLANEOUS TROUBLE Chart 9 TROUBLE AND TROUBLESHOOTING MISCELLANEOUS TROUBLE Countermeasure (I-1) Tighten nuts. (I-2) Tighten nuts and insert pins. (I-3) Remove adjustment liner and adjust aperture, or replace. (I-4) Check teeth, shaft, and pushrod of gear for wear. Replace where necessary. (II-1) Tighten adjustment valve. (II-2) Check and repair. (II-3) Clean. (II-4) Repair. (III-1) Clean. (III-2) Add cooling water.
(III-3) Disassemble and repair or replace. (III-4) Tighten adjustment valve. (III-5) Tighten safety valve. (III-6) Change lube oil. (III-7) Add lube oil. (III-8) Replace.