Yanmar — 3.2 Quick reference chart for troubleshooting

3. Troubleshooting (1) Damaged governor bearing INSUFFICIENT POWER OUTPUT (1) Poor quality fuel oil (2) Clogging of exhaust line (3) Seizure of moving parts (5) Insufficient lube oil supplied (4) Insufficient cooling water (VI-1) Clean. (VII-1) Replace with good fuel oil. (VII-2) Clean. (VII-3) Disassemble, check and repair. (VII-4) Lap cooling water pump suction/exhaust valves. (VII-5) Disassemble and clean lube oil pump and filter. Chart 8 INSUFFICIENT POWER OUTPUT (2) Inaccurate length of governor link (III) Faulty governor (VII) Miscellaneous (III-1) Replace. (III-2) Repair.

(1) Clogging of air filter (II) Amount of fuel injection inadequate (1) Clogging of nozzle hole (2) Faulty valve seat (3) Sticking of valve needle (4) Loose high pressure pipe (5) Worn valve needle (6) Clogging of filter (VI) Clogged intake air filter (II-1) Clean nozzle hole or replace. (II-2) Lap or replace. (II-3) Lap or replace. (II-4) Tighten firmly. (II-5) Replace. (II-6) lean. (1) Early injection (2) Late injection (V) Irregular fuel injection timing (V-1) Adjust timing to delay injection. (V-2) Adjust timing to speed injection.

(9) Damaged valve spring (10) Faulty supply pump (8) Clogging of fuel oil pipe (I) Amount of oil supply from fuel injection pump inadequate (1) Worn plunger (6) Inaccurate positioning of adjustment rack (7) Clogging of fuel filter (I-1) Replace. (I-2) Disassemble and repair or replace. (I-3) Lap valves. (I-4) Tighten firmly. (I-5) (I-6) Adjust. (I-7) (I-8) Clean. (I-9) Replace. (I-10) Repair. (IV-1) Lap valves. (IV-2) Adjust. (IV-3) Replace. (IV-4) Replace.

TROUBLE AND TROUBLESHOOTING (2) Sticking of plunger (3) Oil leakage from exhaust valve clearance Countermeasure Cause and Effect Countermeasure 57 Chart 8 TROUBLE AND TROUBLESHOOTING INSUFFICIENT POWER OUTPUT Chart 8 TROUBLE AND TROUBLESHOOTING INSUFFICIENT POWER OUTPUT Countermeasure (I-1) Replace. (I-2) Disassemble and repair or replace. (I-3) Lap valves. (I-4) Tighten firmly. (I-5) (I-6) Adjust. (I-7) (I-8) Clean. (I-9) Replace. (I-10) Repair. (II-1) Clean nozzle hole or replace. (II-2) Lap or replace. (II-3) Lap or replace. (II-4) Tighten firmly. (II-5) Replace. (II-6) lean. (III-1) Replace. (III-2) Repair.