Komatsu — EXITING THE DIAGNOSTICS MODE

OM3210 Operation - Section 32 Operator Cab and Controls Page 32-7 This fault check switch, when moved to the ON (down) position, may be used to activate the engine electronic control system diagnostic codes. When the system detects a fault and one of the indicator lamps (7, 8, 9) illuminates as previously described, this switch will permit determination of the kind of fault(s) detected. Fault Check Switch (11, Figure 32-2) c. After all three digits are flashed, the yellow lamp will flash once, and then the red lamp will repeat the same fault code sequence as before.

Fault Scroll Switch (12, Figure 32-2) This fault scroll switch may be used to scroll through the recorded faults held in memory. It will display only active fault codes. To display the next active fault code, move the switch lever to the UP position momentarily and release (switch is spring-loaded to the center OFF position). Activating the switch again will advance to the next fault code, etc. Once all active fault codes have been displayed, the fault code display sequence will be repeated, starting from the first fault code. Moving the switch lever to the DOWN position momentarily and releasing, permits the system to scroll (as described above) backwards through the fault list.

Determining Fault Codes 1. To determine an active fault, turn the keyswitch to the OFF position and wait until the engine completely stops. 2. Turn keyswitch to ON position (engine NOT running) and hold the fault check switch (11) in the ON position. If active fault codes have been determined as described previously, refer to the appropriate Komatsu engine manual. 3. If there is an active fault: a. The amber/yellow engine maintenance light (8) will flash once. b. There will be a 1-2 second pause, and then the red engine shutdown light (7) will flash out the three digit diagnostic code. Each digit is indicated with up to nine light flashes for each digit.

There is a short pause between each digit of the fault code. 4. The system will code until the fa again. XITING THE DI arting the engine turning the key witch to the OFF osition, will exit the agnostics faul ash mode.