(Protect Engine) (9, Figure 32-2) Refer to Determining Fault Codes. During engine operation, if a fault is detected in the system, a light associated with that condition will turn ON and stay on for Warning faults, or it will turn ON and FLASH for more severe faults that can affect engine operation and require immediate attention. This blue engine maintenance light, when illuminated, indicates an out-of-range condition exists within the fuel temperature, cool- ant, oil, or intake air system(s) of the engine. The light may show initially as a constant On, but will go to flashing On, if the condi- tion is allowed to get worse.
Serious engine damage will occur if operation is continued without correcting the fault. Warning faults (light ON) are ones that require attention in the near future, but in most conditions will not greatly affect performance. Severe faults (light FLASHING) are ones that require immediate attention, because the engine could be significantly affected. Active fault conditions MUST be corrected as soon as possible. Operation - Section 32 Page 32-6 OM3210 Operator Cab and Controls ENGINE ELECTRONIC CONTROL Engine Shutdown Light (Stop Engine) SYSTEM (7, Figure 32-2) The following items (7, 8, 9, 11, & 12, Figure 32-2) When illuminated, this red relate to the engine electronic fuel control system.
engine shutdown light indi- cates a serious engine prob- If an abnormal engine condition develops, the control lem exists. system will record a fault code associated with that condition. By use of a series of indicator lamps and switches, the system will display the numerical fault code. When the keyswitch is turned On, the lamps (7,8, 9) should The fault can be engine disabling. illuminate for about 2 sec- Stop the truck in a safe area, as onds and then turn Off, if no soon as possible. Shutdown the faults are detected in the engine and notify maintenance system. This is a system personnel immediately. lamp test.
Engine Maintenance Light (Check Engine) If a light remains (8, Figure 32-2) On, or if a light This amber/yellow light, when illu- flashes, then active minated, indicates an engine fault faults have been exists. Current engine operation detected by the sys- may proceed, but the machine tem and the engine should be scheduled for check- should not be out/repair as soon as practical. started until the con- dition has been cor- rected. t (Stop Engine) red indi- rob- ault can be engine disabling. the truck in a safe area, as as possible. Shutdown the e and notify maintenance nnel immediately. ght (Check Engine)