Operation - Section 32 OM3210 Page 32-14 Operator Cab and Controls TROUBLESHOOTING THE ASR/ARSC SYSTEM Warning Type 2 If the following occurs in the ASR or ARSC system, it indicates a problem has occurred in one of the sys- tems but the affected system will still continue to operate. The ASR system and the ARSC system share a common controller and therefore troubleshooting one system may involve investigating the other system at the same time. ASR/ARSC caution lamp flashes The systems controller is located in the cab, behind the operator seat.
Central warning lamp remains Off Warning buzzer remains Off When a problem occurs in the system The systems controller is equipped with a self-diag- nostic function. If a problem occurs, a failure code is displayed by the controller LED mounted on the face of the controller. Some failure codes are common to both the ASR and the ARSC system circuits while others are unique to one system or the other. If the above warning signal appears, the system will continue to function, however the system should be turned Off immediately and the problem should be investigated and repaired.
The normal operator controls (foot brake, retarder lever) will still be functional and should be used to control the truck. The Fault Code Table on the following page lists the numeric code, a description of the fault, and an “X” in the Applicable System column indicates whether the fault has occurred in the ASR system or if in the ARSC system, or if the problem is common to and affects both systems. The last column indicates whether it is a Warning Type 1 or 2 (see below). When the system is turned OFF, the caution lamp will also turn Off.
Model Selection, Tire Selection, And Failure Code Display When the key switch is turned On, the codes below are automatically displayed in the following order on the controller LED. Refer to the Shop Service Manual for additional, detailed information regarding troubleshooting proce- dures based on the fault code observed. 1. LEDs all light up. 2. Model Code:78 (represents HD785-5LC) 3. Tire diameter Code: B.- Tire: Large size (standard) There are two levels of failure as recognized by the system and continued operation or system shutdown will vary depending on the warning type: 4. Initial failure code. 5. Failure code that occurred immediately before the failure code in 4.
Warning Type 1 If a serious problem has occurred in the ASR or the ARSC system the following warnings will activate: 6. Failure code that occurred immediately before the failure code in 5. Failure Codes The central warning lamp (11, Figure 32-3) will flash. Refer to Fault Code Table on the following pages for a list of ASR/ARSC system faults and applicable warning type. The warning buzzer will sound. The caution lamp (6) will flash. A failure code is displayed on the LED located on the face of the ASR/ARSC controller to indicate the source of the problem.
The set travel speed display (9, Figure 32-3) is also equipped with a self-diagnostic function, and a failure code is displayed on the set travel speed display. If the above warning signals appear, the system will stop functioning . The normal operator controls (foot brake, retarder lever) will still be functional and should be used to control the truck. E1 - Abnormality in CPU - Turn the key switch ON again or turn the system switch ON again. The system should immediately be turned off and the problem investigated by maintenance personnel. When the system is turned Off, the central warning lamp and caution lamp will also turn Off.
E2 - Abnormality in memory - Turn key switch ON again or turn the system switch ON again.