Komatsu — Recommended Set Speed

OM3210 Operation - Section 32 Operator Cab and Controls Page 32-13 To Cancel Set Travel If the cancel switch is operated for more that 1 second, the control is stopped. When this happens, the travel speed display shows “0”. OR ARSC system travel speeds must be set accord- ing to operating conditions. Refer to Retarding Capacity decal in cab for proper gear range and maximum truck speeds when descending grades. Do not exceed maximum engine speed or brake oil temperature. If the system switch is turned Off, the control is canceled. When the system switch is OFF, the travel speed display turns off. NOTE:

The cancel switch must be operated for at least 1 second (different from other switches) to cancel the control. This is to prevent cancelling operation if the switch is touched accidentally. The ARSC system is actuated only if the system switch is On. If the operator desires to have the system automatically control truck speed on a downhill grade, verify the system switch is ON. Relationship With Exhaust Brake On slippery road surfaces, the wheels may lock when the ARSC system is actuated. IF ROAD CONDITIONS ARE POOR, DO NOT USE THE ARSC SYSTEM.

If the exhaust brake switch (12, Figure 32-3) is in the ON position, the exhaust brake is actuated normally when the accelerator pedal is released if the torque converter lock-up is On. If the truck attempts to exceed the set speed, the ARSC is actuated. If a problem occurs in the system and it becomes impossible to maintain accurate control of the truck, a warning is given, the system will turn Off if a serious problem has occurred and the ASRC system is released. The operator should then use the foot brake and retarder control lever to main- tain control and move the truck to a safe place, then turn the system switch OFF.

If the exhaust brake switch is in the OFF position, the exhaust brake is not actuated when the ARSC is being operated. If the foot brake or retarder control lever are operated, the exhaust brake is actuated normally. If the downhill slope is not steep and the engine brake and exhaust brake have ample effect, the truck will not accelerate to the set travel speed and the ARSC may not be actuated. Recommended Set Speed Set the travel speed so that the engine speed is at least 1800 rpm, and operate the truck keeping the retarder oil temperature gauge in the green range.

If there is danger that the retarder oil may overheat, the ASR/ARSC caution lamp (6, Figure 32-3) will illu- minate and the set travel speed is automatically reduced.