Operation - Section 32 OM3210 Page 32-12 Operator Cab and Controls ARSC SYSTEM ACTUATION The ARSC system is actuated when the system switch (2, Figure 32-3) is On. Traveling Again At Set Speed If the truck repeatedly travels on the same slope, once the travel speed has been set, it is possible to operate the ARSC without performing the setting operation each time. If the set switch on the ARSC set lever (3) is pressed, the travel speed at that moment is set as the downhill travel speed. If the travel speed exceeds the set downhill speed, the retarder is automatically actu- ated.
Before entering a downhill slope, if the travel speed has been adjusted to a speed lower than the set speed displayed on the travel speed display, the ARSC Standby lamp (green) lights and the ARSC is actuated when the accelerator pedal is released. The travel speed set by the operator is displayed on the set travel speed display (9) and is stored in mem- ory. If the accelerator pedal (5) is depressed when the ARSC is being operated, the ARSC is canceled and the speed increases. NOTE: When traveling at a speed greater than the set speed displayed on the travel speed display, the ARSC is not actuated even when the accelerator pedal is released.
When this happens, the ARSC Standby lamp (green) also does not light up. Always adjust the travel speed to a speed lower that the set speed displayed on the travel speed display, and check that the ARSC Standby lamp lights up. If the foot brake (4) or retarder control lever (10) are operated when the ARSC is being used, the truck can be slowed or stopped in the normal manner. To Set Speed The set range for the travel speed depends on the selection of the shift lever as shown below.
Making Fine Adjustments Of Set Travel Speed When the shift lever is at positions D, 5, 4, 3, L, the set speed range is 10 - 55 km/h (6.2 - 34.2 MPH) The tap up and tap down operations are used for making fine adjustment of the set travel speed. To raise the set travel speed 1 km/h (0.6 MPH), push the ARSC set lever (3, Figure 32-3) forward once. The travel speed cannot be set when the shift lever is at N or R. If the actual travel speed is less than 10 km/h (6.2 MPH) when the speed setting button is depressed, 10 km/h is set. To reduce the set travel speed 1 km/h (0.6 MPH), pull the ARSC set lever back once. Release the ARSC set lever after changing the set travel speed.
At all other times, the actual travel speed is set. Notes: To Increase Set Speed If the set switch and cancel are operated at the same time, the cancel operation is given priority. To increase the set speed, depress the accelerator pedal (5, Figure 32-3) to increase speed, and when the desired travel speed is reached, press the set switch on the end of the ARSC set lever (3). The set travel speed will be changed to the new speed. If the set switch and tap up are operated at the same time, the tap up operation is given priority. If the set switch and tap down are operated at the same time, the tap down operation is given priority.
It is possible to adjust the set travel speed up to ±5 km/h (±3.1 MPH) when traveling in ARSC (when the accelerator pedal is released). To Decrease Set Speed To decrease the set speed, operate the retarder con- trol lever (10, Figure 32-3) to reduce speed, and when the desired travel speed is reached, press the set switch on the ARSC set lever (3). The set travel speed will be changed to the new speed. When the accelerator pedal is being depressed, the ARSC is canceled, so it is possible to operate freely in a range from 10 to 55 km/h (from 6.2 to 34.2 MPH). NOTE: After using the retarder control lever to reduce the speed, return it to its original position.