Komatsu — Central Warning Lamp (12, Figure 32-3)

OM3210 Operation - Section 32 Operator Cab and Controls Page 32-11 When traveling downhill, if the Automatic Retard Speed Control (ARSC) system is On and the set but- ton on the end of the ARSC set lever is pressed at the speed that is to be maintained, the retarder is automatically applied when necessary to prevent the travel speed from exceeding the set speed. ARSC SYSTEM CONTROLS ASR/ARSC Caution Lamp (6, Figure 32-3) The caution lamp will light if a problem occurs in the ASR or the ARSC systems. Note: When the key switch is first turned On, the lamp will light for 3 seconds to verify the bulb is functioning.

System Switch (2, Figure 32-3) ARSC Standby Lamp (7, Figure 32-3) This switch is used to turn the ARSC system On/Off by depressing the button. When this lamp is On, it shows that the travel speed is set and that operation of the ARSC is possible. When it is Off, the ARSC is not actuated. Note: The lamp will light up for 3 seconds when the key switch is turned On to check the bulb. ARSC Set Lever (3, Figure 32-3) (Refer to Detail “A”, Figure 32-3) This lever is a multi-function control used as follows: Set Speed Display (9, Figure 32-3) Used when setting the travel speed. Used when making fine adjustments up or down to the set speed.

(Tap Up/Tap Down) The set speed display displays the speed (km/h or MPH) that has been set. When the key switch or the system switch is turned ON, the display initially shows “– –”, and then will display “0” until the speed is set. Used when canceling the set speed. The display turns off when the system switch is OFF. Brake Pedal (4, Figure 32-3) The brake pedal can be used to apply the service brakes even though the ARSC system is activated. It displays “0” when the set value is canceled. Accelerator Pedal (5, Figure 32-3) Retarder Control Lever (10, Figure 32-3) The ARSC system is actuated only when the acceler- ator pedal is released.

Even if the ARSC system is active, the retarder can be controlled with the retarder control lever. Central Warning Lamp (12, Figure 32-3) This lamp lights up together with the ASR/ARSC cau- tion lamp if there is a serious abnormality in the ARSC system when the system switch is On.