Komatsu — PRECAUTIONS WHEN USING THE ASR SYSTEM

Operation - Section 32 OM3210 Page 32-10 Operator Cab and Controls System Switch (1, Figure 32-3) The ASR system switch is used to turn the ASR sys- tem On/Off. PRECAUTIONS WHEN USING THE ASR SYSTEM The operator can operate the truck without the ASR system activated, however extra caution should be used to prevent skidding when driving on slippery roads. ASR/ARSC Caution Lamp (6, Figure 32-3) The caution lamp will light if a problem occurs in the ASR or the ARSC systems. When the key switch is first turned On, the lamp will light for 3 seconds to verify the bulb is functioning. If both rear wheels slip at the same speed, the ASR system will not function.

If this should occur, the operator must adjust engine output using the accelerator pedal. ASR Operation Lamp (8, Figure 32-3) This lamp illuminates when the system detects slip- page of the rear wheels and the ASR system starts working. The ASR system operates when the system switch is turned ON. If a problem occurs within the system and travel cannot be controlled securely, the system will turn Off, the warning buzzer will sound and the ASR system operation will stop. Central Warning Lamp (12, Figure 32-3) This lamp will light along with the ASR caution lamp if there is a serious problem in ASR system when the ASR switch (1) is ON.

Although the ASR system is designed to limit wheel slippage, there may be conditions where the truck cannot be operated safely such as on icy roads or a steep slope. In this situation, the road surface should be repaired before driving. Retarder Control Lever (10, Figure 32-3) When ASR is active and the operator applies the retarder, ASR operation is stopped. On a slippery road, more air is consumed by operation of the ASR system. If the air pressure drops and the warning buzzer sounds, stop the truck in a safe place. Wait until the air pressure returns to normal and then proceed.

Accelerator Pedal (5, Figure 32-3) The ASR system only operates if the accelerator pedal is depressed and the truck speed is within 0 to 30 km/h (0 to 18.6 MPH). When the accelerator pedal is released, ASR operation stops. Brake Pedal (4, Figure 32-3) When ASR is active, if the brake pedal is depressed, ASR operation is stopped.