Komatsu — 36. Panel Dimmer Switch

31. Engine Oil Pressure Monitor This switch (35) is used to change the braking method according to the road conditions. The engine oil pressure monitor (31) indicates low engine oil pressure. This position (switch OUT - light OFF) is used when traveling on normal road surfaces. Braking force is applied to both front and rear wheels. If the lamp flashes and alarm buzzer sounds, stop the engine and carry out inspection. Action code “04” will be indicated. This position (switch IN - light ON) is used when traveling on slippery roads. Braking force is applied only to the rear wheels . 32.

Charge Monitor This switch is present in all instrument panels, but is inactive in trucks without this option. The charge monitor (32) indi- cates an abnormality in the charging system while the engine is running. If the monitor lamp lights up, check the charging circuit. Action code “01” will be indicated. 36. Panel Dimmer Switch The panel dimmer switch (36) is used to adjust the brightness of the lighting inside the monitor panel and pilot lamps. 33. Transmission Oil Filter Monitor The transmission oil filter monitor (33) warns of clogging of the transmission oil filter. If the moni- tor light lights up, replace the transmission filters, and check for contamination in the oil.

Action code “01” will be indi- cated. Adjust as follows: ‰ To increase brightness, turn clockwise. ‰ To decrease brightness, turn counterclockwise. 34. Hazard Warning Lights The hazard warning light switch (34, Figure 32-7) causes all turn signal lights to flash. The switch is OFF when the switch is out. To switch the hazard lights On, depress the switch. If the key switch is ON, the turn signal pilot lamp will flash at the same time. If the key switch is OFF, the turn signal pilot lamp will not flash. 32 OM3210 Operator Cab and Controls 30. Coolant Level Monitor 35. Front Brake O The coolant level monitor (30, Figure 32-7) indicates a low radi- ator coolant level.

If this monitor lamp flashes and alarm buzzer sounds, stop truck, shutdown engine, and add coolant as required. Action code “01” will be indicated. Monitor 35. Front Brake O The coolant level monitor (30, Figure 32-7) indicates a low radi- ator coolant level. If this monitor lamp flashes and alarm buzzer sounds, stop truck, shutdown engine, and add coolant as required. Action code “01” will be n/Off Switch