OM3210 Operation - Section 32 OUT/OFF position. When traveling, always set the lever to FLOAT posi- tion with the body seated. DO NOT PUSH COLD STARTING AID BUTTON AFTER ENGINE HAS STARTED! SERIOUS DAM- AGE TO ENGINE MAY OCCUR! Operator Cab and Controls Page 32-25 37. AISS/Auto Switch The AISS ( selector swit 32-7) may b LOW or AU This switch i operator to speed of the LOW position (switch I the MANUAL POSITIO when fine control movements are n when parking, or driving in/out of conf AUTO position (switc OFF) is used for nor The following conditions 1. When the machine is stopped, t is automatically set to LOW s parking brake or retarder is ON.
ing brake is released to start tra speed is automatically set to HI 2. If the coolant temperature is speed is automatically set to reduce the time taken for the w ation. 38. Manual Starting Aid Switch This truck is eq automatic cold st The cold starting the electric heate intake manifold. Under normal conditions, there is no need to use this MANUAL switch. If the out- side temperature is below - 5°C (23°F) and the prelube starter runs a long time, this manual switch can be pushed IN for 2-3 seconds before starting the engine to maint heating. Refer to Starting The Engine in Cold in this section. The Starting Aid Switch (38) is sprin 39.
Starting Switch automatic idle The starting switch (39, Figure ch, 37, Figure 32-7) is a three-position key- e positioned to switch: TO as desired. OFF Position - Key insertion/ s used by the withdrawal position - None of control the idle the electrical circuits activate in engine. this position. Turn the switch to N - light ON) is OFF to stop the engine. N and is used ON - Lamp circuits activate in this position. eeded, such as ined spaces. START - At this key position, the starting motor will crank the engine. Release the key immediately after h OUT - light engine starts; the key will return automatically to ON. mal operations. occur: Refer to Starting The Engine, earlier in this section.
he idling speed peed when the When the park- 40. Pilot Lamp Bulb Check Switch veling, the idling Turn the starting switch GH speed. (39) to ON and press the low, the idling pilot lamp bulb check HIGH speed to switch (40) to check if arming up oper- bulbs will light. All pilot lamp bulbs should light. uipped with an art aid. 41. Rear Brake Pilot Lamp aid energizes The rear brake pilot lamp (41) rs in the engine lights up when the service brake is depressed or the retarder con- trol lever is pulled to actuate the rear brake. 42.
Body Float Caution Monitor When the dump body control lever is set to any position other ain engine pre- than FLOAT, or the body is not seated on the frame, the body float caution monitor (42) lights Weather, earlier up. g-loaded to the