Operation - Section 32 OM3210 Page 32-26 Operator Cab and Controls 43. Parking Brake Monitor The parking brake monitor (43) lights up when the parking brake is applied. 48. Steering Oil Temperature This lamp (48) indicates a rise in the steering oil temperature. If the lamp comes on, stop the truck and run the engine with no load at 1200-1500 rpm until the caution lamp goes out. Action code “05” will be indicated. 44. Emergency Steering Monitor 49. Not Currently Used If the emergency steering switch (located on center console) is activated, this lamp (44) lights up.
It also lights up when the auto emergency steering is actuated because an abnormality has occurred in the steering hydraulic circuit during travel. 50. Side Slope Warning (Optional) When the dump body is raised, this warns the operator that the machine has tilted beyond the safety range to the left or right. If this monitor (50) flashes, lower the body, and move the machine to a safe, stable place. Action code “07” will be indicated. 45. Exhaust Brake (Optional) The exhaust brake pilot lamp (45) lights up when the exhaust brake is actuated. 51.
Rear Brake Caution Lamp This lamp (51) flashes when the rear brake is operated and the over-stroke sensor in the brake chamber contacts the brake pis- ton. Brake oil pressure below normal level is the usual cause. If this lamp flashes, check the rear brake system immediately. 46. Cold Start The cold start pilot lamp (46) lights up when the automatic cold start is activated or the manual cold start switch on the instru- ment panel is depressed. After inspecting and repairing the rear brake system, be sure to push in the over-stroke sensor installed to the brake chamber. If this operation is neglected, the brake line trouble warning will continue to operate. Action code “01” will be indicated.
47. Not Currently Used