When the steering wheel turning (turn left) Control valve When the steering wheel turns left, the turning bring the match of spline, cause the steering shaft also turns left. Because the valve sleeve is connected with valve cartridge by using of spring laminations, the valve cartridge compact the spring laminations, bring about the turning angle difference between the valve sleeve and valve cartridge, which make all holes in the valve sleeve are all connected with slots of valve cartridge.
While turning steering wheel, there will be an angular displacement between valve spool and valve pocket, and when it reaches to a value, the median throttle edges CO will close, and pressure of oil through steering gear’s changing- throttle edges C1 will reduce. Thus the pressure of C1 will pass to both ends of priority valve spool, and make it to find a new balance.
When the speed of turning steering wheel increased, at the changing moment, flow through steering gear less than the product between The speed of steering wheel and The output volume of steering gear, and the speed of valve pocket drived by metering device less than the speed of valve spool drived by steering wheel, all these lead to an increasing of angular displacement between valve spool and valve pocket, and increasing of aperture of throttle edges C1, so at this moment, it needs larger flow to create the same differential pressure before to push priority valve spool to right-shift.
therefore, the aperture of valve port connected to CF oil-way will increasing as the increasing turning speed of steering wheel, and finally oil supply will meet the product between the speed of steering wheel and the output volume of steering gear. 20-58 Contr ol valve