The coolant level must be checked on a cold en- gine since the level varies with engine tempera- 2. Check the coolant level in the coolant reser- voir. The coolant should be between the minimum and 3. If the coolant is at or below the minimum level mark, remove panel D. (See page 8-8.) maximum level marks. 1. Maximum level mark 2. Minimum level mark NOTE: NOTE: ture. 8-31 Be sure no foreign material enters the differen- 6. Install the oil filler bolt, and then tighten it to the specified torque. 7. Check the differential gear case for oil leak- age. If oil is leaking, check for the cause. EBU23470 Coolant The coolant level should be checked before each ride.
In addition, the coolant must be changed at the intervals specified in the periodic maintenance and lubrication chart. EBU27122 To check the coolant level 1. Place the ATV on a level surface. Tightening torque: Differential gear oil filler bolt: 23 Nm (2.3 m·kgf, 17 ft·lbf) CAUTION: tial gear case. ECB00410 8