Yamaha YFM7FGPW — PERIODIC MAINTENANCE AND MINOR REPAIR

8 Never run the engine in an enclosed area when purging the spark arrester, otherwise it could cause injury to the eyes, burns, carbon monox- ide poisoning, possibly leading to death, and start a fire. G Always let the exhaust system cool prior to touching exhaust components. G Always wear eye protection, and make sure no one is behind the ATV. G Make sure there are no combustible materi- EBU23930 V-belt case drain plug After riding in water deep enough to allow it to en- ter the V-belt case, remove this plug to drain the water from the case. If water drains from the V-belt case after removing the plug, have a Yamaha dealer check the ATV as the water may affect other engine parts.

WARNING als in the area. EWB02380 NOTE: 8-42 7. Start the engine and rev it up approximately twenty times while momentarily creating ex- haust system back pressure by blocking the end of the muffler with a shop towel. 8. Stop the engine and allow the exhaust pipe to cool. 9. Install the purging bolt and tighten it to the specified torque. Tightening torque: Purging bolt: 27 Nm (2.7 m·kgf, 19 ft·lbf) 1. Purging bolt WARNING