6 For maximum engine life, always warm the en- gine up before starting off. Never accelerate The engine is warm when it responds normally to Before shifting, stop the ATV, otherwise the Shifting: Neutral to High-range and High-range to Low-range 1. Bring the ATV to a complete stop. 2. Apply the brake pedal, and then shift by mov- ing the drive select lever along the shift guide. EBU20440 Operating the drive select lever and driving in reverse transmission may be damaged. hard when the engine is cold! CAUTION: the throttle. CAUTION: ECB00160 NOTE: ECB00170 6-2 This model is equipped with an ignition circuit cut- off system. The engine can be started under the following conditions:
G The drive select lever is in the neutral or park po- sition. G The rear brake lever or brake pedal is applied with the drive select lever in any position. How- ever, it is recommended to shift into the neutral 3. Apply the rear brake lever or brake pedal. 4. Completely close the throttle lever and start the engine by pushing the start switch. If the engine fails to start, release the start switch, then push it again. Pause a few seconds before the next attempt. Each cranking should be as short as possible to preserve battery energy. Do not crank the engine more than 10 seconds on each 5. Continue warming up the engine until it idles smoothly. or park position before starting the engine.
NOTE: NOTE: attempt. CAUTION: