10 Structure, function and maintenance standard SEN01352-00 2. At hold and when load pressure (P2) is low. NOTE: When load pressure (P2) is lower than output pressure (PR) of the self pressure reducing valve. 3. When load pressure (P2) is high. q If load pressure (P2) increases and the pump discharge amount also increases because of operations, pressure (P1) also increases (pressure (P1) > force of spring (7) + (area (Шd) x pressure (PR)), so valve (2) moves to the right to the end of the stroke. q Valve (2) receives force in the direction to close the passage from port (P1) o (P2) from spring (3) and pressure (PR) (when the engine is stopped, the pressure is 0 MPa {0 kg/cm 2 }).
q However, when hydraulic oil flows in from port (P1), the pressure is balanced so that pressure (P1) = force of spring (7) + (area (Шd) x pres- sure (PR)), and the opening from port (P1) o (P2) is adjusted so that pressure (P1) is kept at a certain value above pressure (PR). q As a result, the amount of opening from port (P1) o (P2) increases and the resistance in the passage is reduced, so the loss of engine horsepower is reduced. q If pressure (PR) goes above the set pressure, poppet (5) opens and the hydraulic oil flows in the following circuit: port (PR) o hole (a) inside spool (8) o opening of poppet (5) o tank port (T).
q When pressure (PR) goes above the set pres- sure, poppet (5) opens, and the hydraulic oil flows in the following circuit: port (PR) o hole (a) inside spool (8) o opening of poppet (5) o tank port (T). q As a result, a pressure difference is created on both sides of hole (a) inside spool (8), so spool (8) moves in the direction to close the opening from port (P1) o (PR). Pressure (P1) is reduced to a certain pressure (set pressure) by the amount of opening at this point, and is sup- plied as pressure (PR). (See Fig. 3) q As a result, a pressure difference is created on both sides of hole (a) inside spool (8), so spool (8) moves in the direction to close the opening from port (P1) o (PR).
Pressure (P1) is reduced to a certain pressure (set pressure) by the amount of opening at this point, and is sup- plied as pressure (PR). (See Fig. 2) BR380JG-1E0 13