Kaiyi BR380JG-1E0 — RELEASING RESIDUAL PRESSURE FROM FUEL SYSTEM

30 Testing and adjusting SEN02303-00 Handling fuel system parts 1 Releasing residual pressure from fuel system 1 a Precautions for checking and maintaining fuel system The common rail fuel injection system (CRI) consists of more precise parts than the con- ventional fuel injection pump and nozzle. If for- eign matter enters this system, it can cause a trouble. When checking and maintaining the fuel sys- tem, take care more than the past. If dust, etc. sticks to any part, wash that part thoroughly with clean fuel. a Precautions for replacing fuel filter cartridge Be sure to use the Komatsu genuine fuel filter cartridge.

Since the common rail fuel injection system (CRI) consists of more precise parts than the conventional fuel injection pump and nozzle, it employs a high-efficiency special filter to pre- vent foreign matter from entering it. If a filter other than the genuine one is used, the fuel system may have a trouble. Accordingly, never use such a filter. a Pressure is generated in the low-pressure cir- cuit and high-pressure circuit of the fuel sys- tem while the engine is running. Low-pressure circuit: Feed pump – Fuel main filter – Supply pump High-pressure circuit:

Supply pump – Common rail – Injector a The pressure in both low-pressure circuit and high-pressure circuit lowers to a safety level automatically 30 seconds after the engine is stopped. a Before the fuel circuit is checked and its parts are removed, the residual pressure in the fuel circuit must be released completely. Accord- ingly, observe the following. k Before checking the fuel system or remov- ing its parts, wait at least 30 seconds after stopping the engine until the residual pres- sure in the fuel circuit is released. (Do not start the work just after stopping the engine since there is residual pressure.) BR380JG-1E0 15