SEN02303-00 30 Testing and adjusting Measuring fuel pressure 1 2) Install adapter G2 and nipple [1] of hydraulic tester G1 and connect them to oil pressure gauge [2]. a Use the oil pressure gauge of 2.5 MPa {25 kg/cm 2 }. a Measuring tools for fuel pressure k Stop the machine on a level ground. a Measure only the fuel pressure in the low-pres- sure circuit from the feed pump through the fuel main filter to the supply pump and the return circuit from the supply pump/common rail/injector to fuel tank. k Since the pressure in the high-pressure cir- cuit from the supply pump through the common rail to the injector is very high, it cannot be measured.
3) Run the engine at low idle and measure the pressure in the fuel low-pressure cir- cuit. a If the pressure in the fuel low-pres- sure circuit is in the following range, it is normal. 1. Measuring pressure in fuel low-pressure circuit 1) Open the engine hood and remove fuel pressure pickup plug (1) from the fuel main filter. k If the engine cannot be started, you may measure the fuel pressure while rotating the engine with the starting motor. Do not rotate for more than 20 seconds continu- ously, however, for protection of the starting motor. 4) After finishing measurement, remove the measuring tools and return the removed parts. 3 Fuel pressure pickup plug:
10 ± 2 Nm {1 ± 0.2 kgm} 16 BR380JG-1E0 Symbol Part No. Part name G 1 799-101-5002 Hydraulic tester 790-261-1204 Digital hydraulic tester 2 6732-81-3170 Adapter (10 × 1.0 mm o R1/8) 6215-81-9710 O-ring 3 799-401-2320 Hydraulic gauge At low idle 0.5 – 1.3 MPa {5.1 – 13.3 kg/cm2} During cranking 0.3 – 1.1 MPa {3.1 – 11.3 kg/cm2}