Kaiyi BR380JG-1E0 — CHECKING AND ADJUSTING TRACK SHOE TENSION

30 Testing and adjusting SEN02303-00 Checking and adjusting track shoe tension 1 Adjusting a If the track shoe tension is abnormal, adjust it according to the following procedure. Checking 1. Run the engine at low idle and drive the machine forward by the length of track on ground, and then stop slowly. 1. Increasing tension 1) Add grease through grease fitting (1) with a grease gun. 2) To check that the tension is normal, run the engine at low idle and move the machine forward by the length of track on ground, then stop slowly. 3) After adjusting, check the track shoe ten- sion again according to the above proce- dure. 2.

Place steel bar [1] on the track shoe between the idler and the 1st carrier roller. a As the steel bar, use an angle steel, etc. which will be deflected less. 3. Measure maximum clearance (a) between steel bar [1] and track shoe. q Standard maximum clearance (a): 10 – 30 mm a You may add grease until dimension (b) between the idler guide and track frame end becomes 0 mm. If the tension is still low, the pins and bushings are worn much. In this case, reverse or replace the pins and bushings. BR380JG-1E0 23