Kaiyi BR380JG-1E0 — MEASURING AND ADJUSTING OIL PRESSURE IN WORK EQUIPMENT AND TRAVEL CIRCUITS

30 Testing and adjusting SEN02303-00 Adjusting a The unload valve cannot be adjusted. 2. Adjusting work equipment safety valves a If the work equipment safety valves are abnormal, adjust safety valves (7), (8), (10) and (11) of the work equipment according to the following procedure. 1. Adjusting main relief pressure (Travel) a If the main relief pressure is abnormal, adjust main relief valves (3) and (4) according to the following procedure. q (7) : Motor for magnetic separator q (8) : For side conveyor motor q (3): Rear (R) main relief valve q (4): Front (F) main relief valve q (10) : For feeder motor q (11) :

For resetting lock cylinder 1) While fixing adjustment screw (5), loosen locknut (6). 2) Turn adjustment screw (5) to adjust the set pressure. a If the adjustment screw is 1) Loosen locknut (12). Turn adjustment nut (13) to adjust the pressure. a If the adjustment nut is q Turned to the right, the set pres- sure is increased. q Turned to the right, the set pres- sure is increased. q Turned to the left, the set pres- sure is decreased. a Quantity of adjustment per turn of adjustment nut: Approx. 25.3 MPa {Approx. 258 kg/cm 2 } 2) While fixing adjustment nut (13), tighten locknut (12). q Turned to the left, the set pres- sure is decreased. a Quantity of adjustment per turn of adjustment screw:

Approx. 12.6 MPa {Approx. 128 kg/cm 2 } 3) While fixing adjustment screw (5), tighten locknut (6). 3 Locknut: 39 – 49 Nm {4 – 5 kgm} 3 Locknut: 29.4 – 39.2 Nm {3 – 4 kgm} 4) After finishing adjustment, check again that the oil pressure is normal according to the above described measurement procedure. BR380JG-1E0 27